TBI-HS / Speed + low torque
Start a speed, torque and signal review for compact rotary test fixtures and precision gimbals with limited mass and bearing drag.
Typical design brief: EO/IR gimbals, camera platforms and high-speed test stands.
IMPERIAL / METRIC SELECTION ENVELOPE
These are design request ranges, not an orderable stock specification. Exact dimensions, current derating and maximum speed require a released drawing.
| Model / family | Thru-bore ID (in / mm) | OD × L (mm) | Power circuits | Signal / data channels | Max speed (RPM) |
|---|---|---|---|---|---|
| TBI-HS 6–60 requested circuits | Metric 3 mm / ≈0.118 in | Drawing review required | Current, mass and heat review | RF / encoder / low-level signal review | 2,000–10,000 RPM design requests |
| TBI-HS 6–60 requested circuits | 1/8 in / 3.175 mm | Drawing review required | Current, mass and heat review | RF / encoder / low-level signal review | 2,000–10,000 RPM design requests |
| TBI-HS 6–60 requested circuits | Metric 12 mm / ≈0.472 in | Drawing review required | Current, mass and heat review | RF / encoder / low-level signal review | 2,000–10,000 RPM design requests |
| TBI-HS 6–60 requested circuits | Metric 25 mm / ≈0.984 in | Drawing review required | Current, mass and heat review | RF / encoder / low-level signal review | 2,000–10,000 RPM design requests |
Exact imperial conversions: 0.5″ = 12.7 mm · 1″ = 25.4 mm · 1.5″ = 38.1 mm · 2″ = 50.8 mm · 3″ = 76.2 mm · 4″ = 101.6 mm. Metric 50 / 70 / 100 mm bores remain separate choices.
APPLICATION REVIEW
Maximum RPM, low starting torque, large bore and long life cannot be assumed simultaneously. Balance, bearing heat and wire routing require model-specific validation.
For a shaft-mounted design, secure the rotor as its drawing specifies and restrain the stator with an anti-rotation tab that accommodates misalignment. Avoid rigidly locking both sides. Mounting is model-specific; flange and capsule designs may differ.
Read the mounting checklist →CONNECTORS / LEADS / ENCLOSURE
Choose termination, wire length and mounting options below. Displayed accessory amounts are planning allowances; compatibility and final cost are confirmed with the quotation.
It is a design request ceiling, not a released model rating. The quotation must identify bore, circuit count, duty, balance and verified speed.
Specify frequency range, 50-ohm or other impedance, channel count, insertion loss, return loss and rotary variation targets.
DEFINE THE ROTATING INTERFACE
Send your shaft size, current, data interface and duty. Request a drawing and configuration-specific quotation.
